Bnc 7000 Series Programmer Manual Instrukcja Użytkownika Pobierz pdf (Strona 22)

5 SCPI Command Description

5.1

:ABORt Subsystem

The :ABORt command is a single command subsystem. There are no subcommands or associated

data parameters, as shown below. The :ABORt command, along with the :TRIGger and :INITiate

commands, comprise the Trigger group of commands.

Command

Parameters

Unit

(default)

Remark

:ABORt

FW 1.0

:ABORt

This command causes measurement or sweep in progress to abort. Even if INIT:CONT[:ALL] is set to

ON, the sweep will not immediately re-initiate.

5.2

:CALCulate Subsystem

The CALCulate subsystem performs post acquisition data processing. Functions in the SENSe

subsystem are related to data acquisition, while the CALCulate subsystem operates on the data

acquired by a SENSe function.

The subsystem works for BB (baseband noise), and PN (phase noise), respectively.

Command

Parameters

Unit

(default)

Remark

:CALCulate:PN:TRACe:HOLD

{OFF|MAX|MI

OFF

:CALCulate:FREQuency?

:CALCulate:POWer?

dBm

:CALCulate:XX:SPOT?

dBc/Hz

FW 1.0

:CALCulate:PN:TRACe:FREQuency?

:CALCulate:PN:TRACe:SPECtrum?

dBc/Hz

:CALCulate:BB:TRACe:NOIse?

dBV/Hz

FW 1.0

:CALCulate:PN:TRACe:SPURious:FREQuency?

FW 1.0

:CALCulate:PN:TRACe:SPURious:POWer?

dBc

FW 1.0

:CALCulate:PN:TRACe:FUNCtion:AVARiance?

FW 1.0

:CALCulate:PN:INTegral?

FW 1.0

:CALCulate:PN:JITter?

FW 1.0

Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901

Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected]om, Web: www.berkeleynucleonics.com

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 36 37

Komentarze do niniejszej Instrukcji

Brak uwag

Bnc 7000 Series Programmer Manual Instrukcja Użytkownika Strona 22

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Generatory Bnc 7000 Series Programmer Manual